Pages

Selasa, 11 Oktober 2016

Laminating the front seat More painting

I decided to start working on the forward thwart. Both thwarts are cut from 22/32" AC exterior-grade plywood. My plan is to laminate 1/4" Meranti plywood onto the top, so that the seats will match the deck and the transom.


My original plan was to stain the sides of the lighter-colored AC plywood. However, Ive changed my mind & now plan to paint the sides Sea Foam Green to match the accent color on the sheers.

The forward thwart is 12" long x 45" wide at the base. (The sides are bevelled, so the top is wider than the bottom). Luckily, I had a piece of Meranti large enough to use, so I dont yet have to cut into one of the remaining sheets.

I cut out the middle section of it, arranging it so that it will have an attractive grain pattern showing on the top of the seat.

Grain pattern for the forward thwart.

Then I turned it over and coated it with epoxy. I coated the mating surface of the AC plywood thwart with epoxy, and stuck them together. Since the whole thing was laying flat, with flat mating surfaces, I did not use thickened epoxy. I weighted the thwart down with concrete blocks and a paint can to get good adhesion.

I set the whole thing on waxed paper to avoid accidentally gluing it to my working surface.

With the remaining epoxy from the batch, I added a 2nd layer to encapsulate the aft section of the boat. I got the port side done before I ran out of epoxy. Once it cured, it was ready for paint.

Half of the aft section with 2 layers of epoxy.

Once the epoxy on the thwart cured, I put the whole assembly in my bench vise for further work.

First layer of Whidbey White painted in the aft section.

Cleat removed from the port quarter knee; quarter knee taped off, and more paint applied to the back.


A light frosting of paint on the underside of the thwart.


A third coat of Whidbey White on everything but the transom.




Related Posts by Categories

0 komentar:

Posting Komentar